Bullet 1000 DF with clear glass

• Made in Germany
• ECE-tested for the rear
• Replace the existing brake / taillight and indicators
• Unique, homogeneous light ring
• Extreme light output
• HPT - Homogenous Projection Technology
• Kellermann HighPower LED technology
• Long Life Protection Guard ®, IC controlled,
• 330 kHz clocked
• High-quality metal housing
• Suitable for 12 volt vehicle electrical systems
• With M8 x 20 fastening
thread • Design protected throughout Europe

Classic meets high-tech

The aim of the Bullet 1000 was to redefine the classic bullet shape using the clear basement design and to equip it with the most modern electronics. A highlight of the product is the newly developed lighting technology (Kellermann-HPT), which as a result enables homogeneous, ring-shaped radiation and once again sets standards. Because design quality does not stop with the product shape and the product surface, but is also defined by the light emitted. The high-quality metal housing with a maximum diameter of 39 mm looks discreetly as a piece of jewelry on the motorcycle and is available in the surface variants chrome, black and matt chrome. The Bullet 1000 therefore suits every demanding bike design. The Bullet 1000 is available in the 3 technology variants Extreme Blinker,

Bullet 1000 DF

The Bullet 1000 DF are the version for mounting as rear indicators with integrated brake / taillight function. They replace the existing indicators, the brake light and the taillight. The light from the two permanently glowing red rings gives the rear of the motorcycle a spectacular look **. When braking, these rings shine extremely brightly and thus reliably attract the attention of the following traffic. The Bullet 1000 DF can be ideally combined with the Bullet 1000 PL or the Bullet 1000 Extreme.

• It may be a load-independent relay or power resistors are required to adapt the flashing frequency.
• Combination of the IC-controlled LONG LIFE PROTECTION GUARD® circuit with high-performance LEDs of the latest design.