HIGHSIDER license plate holder AKRON-RS

The HIGHSIDER license plate holder AKRON-RS adapts perfectly to the lines of your bike thanks to its design.

The model-specific bracket of the AKRON-RS allows it to be mounted on the original attachment points of your bike and thus an exchange without further drilling or cutting.
To avoid damage to cables, all sharp-edged bushings are protected by a rubber membrane grommet.

The license plate is made of sheet steel and is 2 mm thick. The precise cutting is done by laser. After the edging, the weather-resistant, black powder coating follows.
This ensures the optimal fit and durability.
Thanks to the infinitely variable adjustment option, you can bring the plate into the desired position without drilling. There is an additional locking screw to hold the plate in this position.

The indicator brackets of the AKRON-RS are adjustable in width and therefore suitable for all types of accessory indicators. This adjustment option allows you to adjust the position of your turn signals to the most varied of license plates. The 10 mm holes are slotted to the side so that the indicators can be installed without disconnecting them from the wiring harness.

You can also adjust the position of the reflector individually using a slide. An adaptation to the different versions of the EU license plate is therefore no problem.

Two rubber washers are included in the scope of delivery in order to securely screw the license plate together and reduce vibrations. Another rubber buffer supports the license plate on its underside.

Details:
• model-specific bracket
• continuously adjustable indicator holder •
slotted indicator holder for easy installation without cable separation
• continuously adjustable reflector, E-approved
• suitable for European license plates
• continuously adjustable angle of inclination
• additional screw for optimal position
security • easy fixation without further work steps (e.g. drilling)
• easy mounting of the label through elongated holes.

The scope of delivery of the AKRON-RS includes:
• Model-
specific bracket with assembly parts • AKRON-RS license plate
holder • Adjustable indicator brackets
• E-approved reflector with adjustable holder
• Installation

instructions Notes:
• A special indicator bracket is optionally available for the original indicators in the Accessories tab.
• If side reflectors are mounted on your original license plate holder, they must be attached again in a suitable position or replaced with new ones.

Tips:
If you haven't found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different designs, are definitely a good alternative.